Canon LBP 2460 Service Manual - Page 251
Displays when Factory Reset - LTR Power
View all Canon LBP 2460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
CHAPTER 4 Message Meaning Action 63 ERROR CALL NVRAM (EEPROM) error. Turn the power OFF, then turn it FOR SERVICE ON again. If it does not remedy the problem, replace the resident NVRAM. 64 ERROR CALL SRAM in AIR chip error. Replace the video controller FOR SERVICE PCB. 32 DISK ERROR Hard Drive Failure - Write Error - Replace the hard disk. 33 DISK ERROR Hard Drive Failure - Read Failure - Replace the hard disk. COLD RESET Displays when the COLD RESET (letter or No action required although the A4) Power-on sequence is selected. printer will be reset to its factory defaults and any unique settings will have to be reset. COLD RESET A4 Displays when Factory Reset - A4 Power-on No action required. sequence is selected. COLD RESET LTR Displays when Factory Reset - LTR Power- No action required. on sequence is selected. CONTEXT SAVE Context Saving mechanism modified by OS. Press CONTINUE key to ADJUSTED Displayed when printer powered on with continue. context saving enabled, but due to manual recofiguration, there is not enough memory to support it. CONTEXT SAVE Context Saving mechanism modified by Press CONTINUE and printer CHANGE USER. Displayed when going online after will reboot to enable its new modifying context saving. state. RESET TO SAVE RESET verification prompt. This message Two options are available: will appear momentarily and then PAUSED. 1. Press the reset key to enter When a menu item was changed before the the RESET menu and save the printer releases the port on which the last information immediately. This job was processed, such as in the middle of will terminate the current job, a job, or before the port timed out. deleting temporary fonts, macros and buffered data. 2. Press ONLINE and the current job will resume where it left off. The menu items changed will not take effect until the next end of job. DSK FMT The operator has formatted the disk and the No action required. RESTART operation has completed. The system will now restart. FLUSHING... A Reset operation has been performed by The job that has been flushed the Operator in the middle of a job. The will have to be resubmitted. current job is being flushed. FORMATTING... This message displays when the disk is No action required. being formatted. I/O INITIALIZING This message displays when one of the No action required. PSIO cards is being initialized. INSTALL UPPER. This message may display if the upper tray Install the upper tray. is missing. KEY NOT VALID Displays when a key is pressed that is not Press the correct button to 4 - 37