Canon LBP 2460 Service Manual - Page 26

CHAPTER 1 V. INSTALLATION A. Notes This printer is packaged and shipped from the factory after careful adjustments and rigorous inspections. When installing the printer, it is important to demonstrate its performance in the same way as when it passes the factory inspection. The service engineer must sufficiently understand the performance of the printer, install it correctly in a location with an appropriate environment, and conduct sufficient checks of the unit. B. Location Selection Before taking the printer to the customer's premises, you should confirm the following conditions at the installation location. 1. Power supply Use the following power supplies: • Line voltage (AC): 100 - 120V ±10% 220 - 240V -10% +6% • Power frequency: ±2Hz rated frequency 2. Operating environment Install in a location that meets the following conditions: • Level, flat surface • Temperature, humidity within the following ranges: Surrounding temperature: 10 to 32.5°C Surrounding humidity: 20 to 80%RH (relative humidity), without condensation • Cool, well-ventilated space Do not install in the following locations: • Exposed to direct sunlight • If you cannot avoid such a location, hang heavy curtains, etc., to shut out the direct sunlight. • Near magnets and devices that emit a magnetic field • Areas with vibration • Dusty places • Near fire or water 3. Installation space Install the printer a suitable distance from the wall, leaving enough room to operate it (see Figure 1-5-1). When installing the printer on a desk, etc., be sure that it is large enough to accommodate the printer's feet (rubber pads) and sturdy enough to hold its weight. 1 - 14