Dell PowerConnect M6220 User's Guide - Page 101

Device Default Settings To return to device default settings use delete startup-config command at the privileged mode prompt (#), and reboot the device. Once device reloads - it is set with the default settings. console> console>enable console#delete startup-config Startup file was deleted console#reload Management switch has unsaved changes. Are you sure you want to continue? (y/n) y Configuration Not Saved! Are you sure you want to reload the stack? (y/n) y Reloading all switches.. Enabling Remote Management 1. Enter the enable command at the console to enter the Privileged EXEC screen mode as follows: console>enable console# 2. Ensure that the management station is connected to the same network as the CMC. For more info see the Dell Blade Server CMC User's Guide. 3. Enter the config command at the console to enter the Configuration mode as follows: console#config 4. Ensure that the switch has obtained an IP address using the show ip interface out-of-band command. console#show ip interface out-of-band IP Address 10.27.22.168 Subnet Mask 255.255.255.0 Default Gateway 10.27.22.1 ServPort Configured Protocol Current........... DHCP Configuring Dell PowerConnect 99