Dell PowerConnect M6220 User's Guide - Page 341
Protocol Group, Bind IP Subnet to VLAN, Show All, IP Subnet - VLAN Bind Table, Remove, Apply Changes
View all Dell PowerConnect M6220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 341 highlights
Removing a MAC - IP Subnet Entry 1. Open the Bind IP Subnet to VLAN page. 2. Click Show All. The IP Subnet - VLAN Bind Table displays. 3. Check Remove for each entry to remove. 4. Click Apply Changes. The entry/entries are removed, and the device is updated. Binding IP Subnets to VLANs Using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • VLAN Commands Protocol Group In a protocol-based VLAN, traffic is bridged through specified ports based on the VLAN's protocol. Userdefined packet filters determine if a particular packet belongs to a particular VLAN. Protocol-based VLANs are most often used in situations where network segments contain hosts running multiple protocols. Use the Protocol Group page to configure which EtherTypes go to which VLANs, and then enable certain ports to use these settings. To display the Protocol Group page, click Switching > VLAN > Protocol Group in the tree view. Configuring Switching Information 339