Dell PowerConnect M6220 User's Guide - Page 711
IPv4 Multicast > PIM > Static RP Configuration, > Static RP Configuration
View all Dell PowerConnect M6220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 711 highlights
Static RP Configuration Use the PIM Static RP Configuration page to display or remove the configured RP. The page also allows adding new static RPs by clicking the Add button. To access the page, click IPv4 Multicast > PIM > Static RP Configuration or IPv6 Multicast > PIM > Static RP Configuration. Figure 12-40. Static RP Configuration The Static RP Configuration page contains the following fields: • RP Address - Select the slot and port for which data is to be displayed. Slot 0 is the base unit. • Group Address - Specify the group address transmitted in Candidate-RP-Advertisements in Prefix/Length format. • Group Mask - (IPv4) The Group Mask of the RP to be created or deleted. • Prefix Length - (IPv6) Specify the group address prefix length transmitted in Candidate-RP- Advertisements to fully identify the scope of the group which the router will support if elected as a Rendezvous Point. • Remove - Select this box to remove the specified static RP IP Address for the PIM router. After entering all required data, click Apply Changes to configure an interface as a PIM candidate. Configuring the Candidate RP using the CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • PIM Commands Configuring IP Multicast 709