Dell PowerConnect M6220 User's Guide - Page 374

MLD Snooping Global Querier Configuration Use the MLD Snooping Global Querier Configuration page to configure the parameters for the MLD Snooping Querier. To display the Global Querier Configuration page, click Switching > Multicast Support > MLD Snooping > Global Querier Configuration in the tree view. Figure 7-88. MLD Snooping Global Querier Configuration The MLD Snooping Global Querier Configuration page contains the following fields: • IP Address- Specifies the Snooping Querier IPv6 Address which will be used as the source address in periodic MLD queries. This address is used when no address is configured for the VLAN on which the query is being sent. • Snooping Querier Admin Mode - Enables or disables the administrative mode for MLD Snooping for the switch. • MLD Version - Specifies the version of MLD protocol used in periodic MLD queries. • Query Interval (1-1800) - Specifies the time interval in seconds between periodic queries sent by the Snooping Querier. The default value is 60. • Expiry Interval (60-300) - Specifies the time interval in seconds after which the last querier information is removed. The default value is 60. Configuring Global Querier MLD Snooping Settings with CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • MLD Snooping Commands 372 Configuring Switching Information