Dell PowerConnect M6220 User's Guide - Page 296
Storm Control, Admin Status, Description, Apply Changes, Switching > Ports > Storm Control
View all Dell PowerConnect M6220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 296 highlights
5. Admin Status and Description can now be edited as needed. 6. Click Apply Changes. The LAG parameters are saved to the switch. Configuring LAGs with CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • Port Channel Commands Storm Control A broadcast storm is the result of an excessive number of broadcast messages simultaneously transmitted across a network by a single port. Forwarded message responses can overload network resources and/or cause the network to time out. Your switch measures the incoming broadcast/multicast/unknown unicast packet rate per port and discards packets when the rate exceeds the defined value. Storm control is enabled per interface, by defining the packet type and the rate at which the packets are transmitted. Use the Storm Control page to enable and configure storm control. To display the Storm Control interface, click Switching > Ports > Storm Control in the tree view. Figure 7-27. Storm Control The Storm Control page contains the following fields: • Port - Specifies the Unit and Port for which storm control is enabled. • Storm Control Mode - Specifies the mode of broadcast affected by storm control. - Broadcast - If the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. 294 Configuring Switching Information