Dell PowerConnect M6220 User's Guide - Page 550
Tunnels Summary, Tunnels Configuration, Tunnel, Delete Tunnel, Routing > Tunnels > Summary
View all Dell PowerConnect M6220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 550 highlights
Removing a Tunnel 1. Open the Tunnels Configuration page. 2. Specify the tunnel to remove in the Tunnel drop-down menu. 3. Click Delete Tunnel. The tunnel is deleted, and the device is updated. Configuring a Tunnel using CLI Commands For information about the CLI command that performs this function, see the following chapter in the CLI Reference Guide: • Tunnel Interface Commands Tunnels Summary Use the Tunnels Summary page to display a summary of configured tunnels. To display the page, click Routing > Tunnels > Summary in the tree view. Figure 9-55. Tunnels Summary The Tunnels Summary page contains the following fields: • Tunnel ID - The Tunnel ID. • Tunnel Mode - The corresponding mode of the Tunnel. • IPv6 Mode - Shows whether IPv6 is enabled on the tunnel. • Source - The corresponding Tunnel Source Address. In the case where an interface has been configured both the interface and the address are displayed. If the source interface has no address configured then nothing is displayed in place of the address. • Destination - The corresponding Tunnel Destination Address. • Tunnel ID - The Tunnel ID. 548 Configuring Routing