Dell PowerConnect M6220 User's Guide - Page 516

Configuring the RIP Interface 1. Open the RIP Interface Configuration page. 2. Specify the interface for which data is to be configured. 3. Enter data into the fields as needed: Send Version - From the drop-down box, select None, RIP-1, RIP-1c, or RIP2. Receive Version - From the drop-down box select None, RIP-1, RIP-2, or Both. RIP Admin Mode - Select Enable or Disable. Authentication Type - Click the Modify button to configure different Authentication Types. 4. Click Apply Changes when finished. The RIP interface is configured, and the device is updated. Selecting an Authentication Method 1. Open the RIP Interface Configuration page. 2. Specify the interface for which the authentication method is to be configured. 3. Click Modify. The Authentication Method page displays. 4. Specify the Authentication Type (None, Simple, or Encrypt) from the drop-down menu. 5. If you specify Simple or Encrypt as the Authentication Type, additional fields appear. Enter the Authentication Key (Simple or Encrypt) and Authentication Key ID (Encrypt). 6. Click Apply Changes. 7. The authentication method is updated, and the device is updated. Configuring the RIP Interface with the CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • Routing Information Protocol (RIP) Commands RIP Route Redistribution Configuration Use the RIP Route Redistribution Configuration page to configure the RIP Route Redistribution parameters. The allowable values for each fields are displayed next to the field. If any invalid values are entered, an alert message is displayed with the list of all the valid values. 514 Configuring Routing