Dell PowerConnect M6220 User's Guide - Page 88
boot system, show version, system, boot system image2, reload, Configuration Not Saved
View all Dell PowerConnect M6220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
TFTP Filename PC8024v3.1.0.x.stk Data Type Code Destination Filename image Management access will be blocked for the duration of the transfer Are you sure you want to start? (y/n) y 5. Select the image for the next boot by entering the boot system command. After this command, enter the command show version to verify that the copy indicated as a parameter in the boot system command is selected for the next boot. The following is an example of the information that appears: console#boot system image2 Activating image image2 .. console>show version Image Descriptions image1 : default image image2 : Images currently available on Flash unit image1 image2 current-activenext-active 1 3.1.0.0 3.1.0.1 image1 image2 If the image for the next boot is not selected by entering the boot system command, the system boots from the currently active image (image1, as given in the example). 6. Enter the command reload. The following message displays: console#reload Management switch has unsaved changes. Are you sure you want to continue? (y/n) 7. Enter y. The following message then displays. Configuration Not Saved! Are you sure you want to reload the stack? (y/n) 8. Enter y to reboot the switch. 86 Configuring Dell PowerConnect