Dell PowerEdge R805 Hardware Owner's Manual (PDF) - Page 110
Installing the Optical Drive, Connect the cable to the SATA_A connector on the system board. See
View all Dell PowerEdge R805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
4 To remove the optical drive, pull up on the blue release tab at the back of the optical drive tray and push the tray out of the system. See Figure 3-24. Installing the Optical Drive 1 Align the optical drive tray with its opening in the front panel. See Figure 3-22. 2 Slide in the drive tray until the tray snaps into place. 3 Connect the optical drive cable to the back of the drive tray. 4 If not already done, connect the power and interface cables from the optical drive to the SAS/SATA backplane and system board connectors. a Connect the power cable to the CD_PWR connector on the backplane board. See Figure 6-3 for the location of the connector and Figure 3-22 for the routing of the cable. b Route the interface cable along the inside right chassis side panel, inserting the cable under each of the cable routing tabs. See Figure 3-23. c Connect the cable to the SATA_A connector on the system board. See Figure 6-2 for the location of the connector. 5 Close the system. See "Closing the System" on page 71. 6 Replace the bezel. See "Replacing the Front Bezel" on page 70. 7 Reconnect your system and peripherals to their electrical outlets, and turn on the system. 110 Installing System Components