Dell PowerEdge R805 Hardware Owner's Manual (PDF) - Page 36
Table 1-7., System Messages, Message, Causes, Corrective Actions, NVRAM_CLR jumper - bios update
View all Dell PowerEdge R805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Table 1-7. System Messages Message Causes Corrective Actions Alert! Node Interleaving disabled! Memory configuration does not support Node Interleaving. The memory configuration does not support node interleaving, or the configuration has changed (for example, a failed DIMM) so that node interleaving cannot be supported. The system will run but with reduced functionality. Ensure that the memory modules are installed in a configuration that supports node interleaving. Check other system messages for additional information for possible causes. For memory configuration information, see "General Memory Module Installation Guidelines" on page 114. If the problem persists, see "Troubleshooting System Memory" on page 150. Attempting to update Remote Configuration. Please wait... Remote Configuration request has been detected and is being processed. Wait until the process is complete. BIOS Update Remote BIOS update Attempt Failed! attempt failed. Retry the BIOS update. If problem persists, see "Getting Help" on page 175. Caution! NVRAM_CLR jumper is installed on system board. NVRAM_CLR jumper is installed. CMOS has been cleared. Remove NVRAM_CLR jumper. See Figure 6-1 for jumper location. CPUs with different cache sizes detected! Microprocessors with different cache sizes are installed. Ensure that all microprocessors have the same cache size and that they are properly installed. See "Processors" on page 120. Decreasing Faulty or improperly installed See "Troubleshooting System available memory memory modules. Memory" on page 150. 36 About Your System