Dell PowerEdge R805 Hardware Owner's Manual (PDF) - Page 31
E201A SIO Err, E2018 Prog Timer - ram
View all Dell PowerEdge R805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Table 1-6. LCD Status Messages (continued) Code Text Causes Corrective Actions E1B01 USB# Overcurrent Device plugged in the specified USB port caused an overcurrent condition. Reseat the device cable. If the problem persists, replace or remove the device. E2010 No Memory No memory is installed in the system. Install memory. See "Installing Memory Modules" on page 117. E2011 Mem Config Err Memory detected, but is not See "Troubleshooting configurable. Error detected System Memory" on during memory page 150. configuration. E2012 Unusable Memory Memory is configured, but See "Troubleshooting not usable. Memory System Memory" on subsystem failure. page 150. E2013 Shadow BIOS Fail The system BIOS failed to copy its flash image into memory. See "Troubleshooting System Memory" on page 150. E2014 CMOS Fail CMOS failure. CMOS RAM See "Getting Help" on not functioning properly. page 175. E2015 DMA Controller DMA controller failure. See "Getting Help" on page 175. E2016 Int Controller Interrupt controller failure. See "Getting Help" on page 175. E2017 Timer Fail Timer refresh failure. See "Getting Help" on page 175. E2018 Prog Timer Programmable interval timer error. See "Getting Help" on page 175. E2019 Parity Error Parity error. See "Getting Help" on page 175. E201A SIO Err SIO failure. See "Getting Help" on page 175. E201B Kybd Controller Keyboard controller failure. See "Getting Help" on page 175. About Your System 31