Dell S2810dn Dell Smart Printer Users Guide - Page 150

Google Cloud Print Disable Enable* Disables Google Cloud Print. Enables Google Cloud Print. *1 HTTP-SSL/TLS feature is available only when a digital certificate is set from the Dell Printer Configuration Web Tool. IP Filter NOTE: IP Filter feature is available only for LPD or Port9100. Purpose: To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP addresses. The change becomes effective after the printer is turned off and then on again. Values: No. n / IP Address (n is 1-5.) No. n / Mask (n is 1-5.) No. n / Mode (n is 1-5.) Off* Accept Reject Sets the IP address for Filter n. Sets the address mask for Filter n. Disables the IP Filter feature for Filter n. Accepts an access from the specified IP address. Rejects an access from the specified IP address. IEEE 802.1x NOTE: IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is available only when the IEEE 802.1x authentication is enabled. Purpose: To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on again. Reset LAN Purpose: To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting the printer, all wired network settings are reset to their default values. Delete All Certificates Purpose: To delete all certificates of the printer. After executing this function and rebooting the printer, all certificates are deleted. PS Data Format Purpose: To specify PostScript3 Compatible communication protocol, you can configure the PS Data Format settings. The change becomes effective after the printer is turned off and then on again. Values: Auto Standard BCP Used when auto-detecting the PostScript3 Compatible communication protocol. Used when the communication protocol is in ASCII interface. Used when the communication protocol is in binary format. 150 Understanding the Printer Menus