Dell S2810dn Dell Smart Printer Users Guide - Page 151

TBCP* Binary Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Used when no special processing is required for data. USB Settings Use the USB Settings menu to change printer settings affecting a USB port. USB Port Purpose: To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on again. Values: Disable Enable* Disables the USB interface. Enables the USB interface. PS Data Format Purpose: To specify PostScript 3 Compatible communication protocol, you can configure the PS Data Format settings. The change becomes effective after the printer is turned off and then on again. Values: Auto Standard BCP TBCP* Binary Used when auto-detecting the PostScript 3 Compatible communication protocol. Used when the communication protocol is in ASCII interface. Used when the communication protocol is in binary format. Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Used when no special processing is required for data. Job Time-out Purpose: To specify the amount of time the printer waits for data to arrive from the computer. The print job is canceled if the time-out time is exceeded. Values: Off On* 30 seconds* Available Range: 5-300 seconds Disables the job time-out. Sets the time the printer waits for data to arrive from the computer. System Settings Use System Settings to configure the power saving mode, warning tones, time-out duration, display language, and job log auto print settings. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Understanding the Printer Menus 151