Dell S2810dn Dell Smart Printer Users Guide - Page 291
The output is too light, Status, Non-Dell, Toner, Tool Box, Maintenance, Printer, Non-Dell Toner
View all Dell S2810dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 291 highlights
• Vertical blanks • Ghosting • Light-induced fatigue • Fog • Bead-Carry-Out (BCO) • Jagged characters • Banding • Auger mark • Wrinkled/Stained paper • Damage on the leading edge of paper The output is too light Action 1 The toner cartridge may be low or need to be replaced. Confirm the amount of toner left in the toner cartridge. a Check the toner level in the Status tab in the Status Monitor. b Replace the toner cartridge as necessary. Does this solve your problem? 2 If you are using non-Dell brand toner cartridge, enable the Non-Dell Toner option. a Launch the Tool Box, and click Maintenance on the Printer Maintenance tab. b Ensure that the On check box under Non-Dell Toner is selected. Does this solve your problem? 3 Disable the Toner Saver in the printer driver. a On the Others tab, ensure that Off is selected in the Toner Saver drop-down menu. Does this solve your problem? 4 The print media surface may be uneven. Try changing the Paper Type setting in the printer driver. For example, change the plain paper to thick. a On the General tab, change the Paper Type setting. Does this solve your problem? 5 Verify that the correct print media is being used. See "Supported Paper Types." If not, use the print media recommended for the printer. Does this solve your problem? Yes The task is complete. The task is complete. The task is complete. The task is complete. The task is complete. No Go to action 2. Go to action 3. Go to action 4. Go to action 5. Go to action 6. Troubleshooting Guide 291