Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1013

Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.5(0.1) 9.2(0.2) 9.0.2.0 8.3.19.0 8.3.7.1 Description Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Usage Information The following describes the show isis database command shown in the following example. Field Description IS-IS Level-1/ Level-2 Link State Database Displays the IS-IS link state database for Level 1 or Level 2. LSPID Displays the LSP identifier. The first six octets are the System ID of the originating router. The first six octets are the System ID of the originating router. The next octet is the pseudonode ID. If this byte is not zero, the LSP describes system links. If this byte is zero (0), the LSP describes the state of the originating router. The designated router for a LAN creates and floods a pseudonode LSP and describes the attached systems. The last octet is the LSP number. An LSP is divided into multiple LSP fragments if there is more data than cannot fit in a single LSP. Each fragment has a unique LSP number. An * after the LSPID indicates that the system originates an LSP where this command was issued. LSP Seq Num LSP Checksum This value is the sequence number for the LSP that allows other systems to determine if they have received the latest information from the source. This is the checksum of the entire LSP packet. Intermediate System to Intermediate System (IS-IS) 1013