Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 272

Version 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Dell Networking OS supports one ingress and one egress MAC ACL per interface. The number of entries allowed per ACL is hardware-dependent. For detailed specifications about entries allowed per ACL, see your line card documentation. NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only. Example Dell(conf)# mac-access-list access-list standard TestMAC Dell(config-std-macl)# permit 00:00:00:00:00:00 00:00:00:00:ff:ff count Dell(config-std-macl)# deny any count Dell(config-std-macl)# permit To forward packets from a specific source MAC address, configure a filter. Syntax permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no permit {any | mac-source-address mac-sourceaddress-mask} command. Parameters any mac-sourceaddress mac-sourceaddress-mask Enter the keyword any to forward all packets received with a MAC address. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). 272 Access Control Lists (ACL)