Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 232

Parameters source any Enter the IP address in dotted decimal format of the network from which the packet was sent. Enter the keyword any to specify that all routes are subject to the filter. You can enter any of the following keywords to specify route types. • bytes - Enter the keyword count to count packets the filter processes. • count - Enter the keyword bytesorder to count bytes the filter processes. • dscp - Enter the keyword dcsp followed by the DCSP value to match to the IP DCSCP values. The range is from 0 to 63. • fragments - Enter the keyword fragments to use ACLs to control packet fragments. • order - Enter the keyword order to specify the QoS order of priority for the ACL entry. The range is from 0 to 254 (0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority). The default is, if you do not use the keyword order, the ACLs have the lowest order by default (255). host ip-address no-drop Enter the keyword host and then enter the IP address to specify a host IP address only. Enter the keywords no-drop to match only the forwarded packets. Defaults Not configured. Command Modes CONFIGURATION-STANDARD-ACCESS-LIST Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.8(0.0) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 Description Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Added the no-drop parameter. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. 232 Access Control Lists (ACL)