Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1804

Example 1 Example 2 1804 To remove the trunk port designation, first remove the port (using the no member interface command) from all stackable VLAN-enabled VLANs. In Example 1, a VLAN-Stack trunk port is configured and then made part of a single-tagged VLAN. In Example 2, the tag protocol identifier (TPID) is set to 8848. The Gi 3/10 port is configured to act as a VLAN-Stack access port; the TenGi 8/0 port acts as a VLANStack trunk port, switching stackable VLAN traffic for VLAN 10, while also switching untagged traffic for VLAN 30 and tagged traffic for VLAN 40. (To allow VLAN 30 traffic, you need the native VLAN feature. Use the portmode hybrid command. For more information, see the portmode hybrid command. Dell(conf-if-gi-1/42)# switchport Dell(conf-if-gi-1/42)# vlan-stack trunk Dell(conf-if-gi-1/42)# show config ! interface GigabitEthernet 1/42 no ip address switchport vlan-stack trunk no shutdown Dell(conf-if-gi-1/42)# interface vlan 100 Dell(conf-if-vl-100)# vlan-stack compatible Dell(conf-if-vl-100-stack)# member gigabitethernet 1/42 Dell(conf-if-vl-100-stack)# show config ! interface Vlan 100 no ip address vlan-stack compatible member GigabitEthernet 1/42 shutdown Dell(conf-if-vl-100-stack)# interface vlan 20 Dell(conf-if-vl-20)# tagged gigabitethernet 1/42 Dell(conf-if-vl-20)# show config ! interface Vlan 20 no ip address tagged GigabitEthernet 1/42 shutdown Dell(conf-if-vl-20)# do show vlan Codes: * - Default VLAN, G - GVRP VLANs Q: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged G - GVRP tagged, M - Vlan-stack NUM Status Description * 1 Inactive 20 Active 100 Active Dell(conf-if-vl-20)# Q Ports T Gi 1/42 M Gi 1/42 Dell(config)# vlan-stack protocol-type 88A8 Dell(config)# interface gigabitethernet 3/10 Dell(conf-if-gi-3/10)# no shutdown Dell(conf-if-gi-3/10)# switchport Dell(conf-if-gi-3/10)# vlan-stack access Dell(conf-if-gi-3/10)# exit VLAN Stacking