Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1867

Version 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 7.4.1.0 6.2.1.1 Description Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced support for telnetting to the VRRP group IP address assigned using this command. Introduced on the E-Series. Usage Information The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When you delete the virtual address, the VRRP group stops sending VRRP packets. A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual IP address with the same address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual IP addresses configured in all VRRP groups. vrrp delay minimum Set the delay time for VRRP initialization after an interface comes up. Syntax vrrp delay minimum seconds Parameters seconds Enter the number of seconds for the delay for VRRP initialization after an interface becomes operational. The range is from 0 to 900 (0 indicates no delay). Defaults 0 Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) Description Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Virtual Router Redundancy Protocol (VRRP) 1867