Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 808

Example • In the event of fragmented packets, the egress port of the subsequent fragments. NOTE: In the show port channel flow command output, the egress port for an unknown unicast, multicast, or broadcast traffic is not displayed. The following example shows the show port-channel-flow outgoing-portchannel number incoming-interface interface source-mac address destination-mac address • Load-balance is configured for MAC • Load-balance is configured for IP 4-tuple/2-tuple • A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address Dell# show port-channel-flow outgoing-port-channel 1 incominginterface gi 3/3 source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00 Egress Port for port-channel 1, for the given flow, is Gi 13/2 Time Domain Reflectometer (TDR) Commands TDR is useful for troubleshooting an interface that is not establishing a link; either it is flapping or not coming up at all. TDR detects open or short conditions of copper cables on 100/1000 Base-T modules. Important Points to Remember • The interface and port must be enabled (configured-refer to the interface command) before running TDR. An error message is generated if you have not enabled the interface. • The interface on the far-end device must be shut down before running TDR. • Because TDR is an intrusive test on an interface that is not establishing a link, do not run TDR on an interface that is passing traffic. • When testing between two devices, do not run the test on both ends of the cable. tdr-cable-test Test the condition of copper cables on 100/1000 Base-T modules. Syntax Parameters tdr-cable-test interface interface Enter the keyword GigabitEthernet then the slot/port information for the 100/1000 Ethernet interface. Defaults None Command Modes EXEC 808 Interfaces