Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1808

management Enter the keyword management to associate an interface to the management VRF. Defaults none Command Modes INTERFACE-CONFIG Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.4.(0.0) Description Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON and Z9500. Introduced on the S-Series and Z9000. Usage Information You can attach an interface to either a nondefault VRF or a management VRF. To assign a port-back to a default VRF, remove the VRF association from the interface. You can use this only if there is no IP address configured on the interface. There must be no prior Layer 3 configuration on the interface when configuring VRF. You must enable VRF before using this command. You can configure an IP subnet or address on a physical or VLAN interface that overlaps the same IP subnet or address configured on another interface only if the interfaces are assigned to different VRFs. If you assign two interfaces to the same VRF, you cannot configure overlapping IP subnets or the same IP address to them. Example Dell# configure terminal Dell(conf)# ip vrf red Dell(conf-vrf)# description "Red Network" Dell(conf-vrf)# show config ! ip vrf red 4 description "Red Network" Dell(conf-vrf)# Dell(conf-if-gi-1/45)# int gi 1/46 Dell(conf-if-gi-1/46)# no shut Dell(conf-if-gi-1/46)# ip vrf forwarding red Dell(conf-if-gi-1/46)# ip add 100.1.1.1/24 Dell(conf-if-gi-1/46)# Dell(conf-if-gi-1/46)# Dell(conf-if-gi-1/46)# Dell(conf-if-gi-1/46)# show config ! interface GigabitEthernet 1/46 ip vrf forwarding red 1808 Virtual Routing and Forwarding (VRF)