Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1274

Version 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 7.5.1.0 pre-6.1.1.1 Description Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Setting the delay and holdtime parameters to a low number enables the switch to an alternate path quickly but requires more CPU usage. Example Dell# conf Dell(conf)# router ospf 1 Dell(conf-router_ospf-1)# timer spf 2 5 Dell(conf-router_ospf-1)# show config ! router ospf 1 timers spf 2 5 Dell(conf-router_ospf-1)# end timers throttle lsa all Configure LSA transmit intervals. Syntax Parameters timers throttle lsa all {start-interval | hold-interval | maxinterval} To return to the default, use the no timers throttle lsa command. start-interval hold-interval max-interval Set the minimum interval between initial sending and resending the same LSA. The range is from 0 to 600,000 milliseconds. Set the next interval to send the same LSA. This interval is the time between sending the same LSA after the startinterval has been attempted. The range is from 1 to 600,000 milliseconds. Set the maximum amount of time the system waits before sending the LSA. The range is from 1 to 600,000 milliseconds. 1274 Open Shortest Path First (OSPFv2 and OSPFv3)