Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 252

To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny {source mask | any | host ip-address} {destination mask | any | host ip-address} command. Parameters source mask any host ip-address destination count bytes dscp order fragments no-drop Enter the IP address in dotted decimal format of the network from which the packet was sent. (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address or hostname. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword bytes to count bytes processed by the filter. (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). Enter the keyword fragments to use ACLs to control packet fragments. Enter the keywords no-drop to match only the forwarded packets. Defaults Not configured. Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) Description Introduced on the S3100 series. 252 Access Control Lists (ACL)