Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1816

Version 9.5(0.0) 9.4.(0.0) Description Introduced on the Z9500. Introduced on the S-Series and Z9000. Usage Information When you use this command, the management ports corresponding to both the active unit and the standby unit are associated with the management VRF. maximum dynamic-routes Specify the maximum number of dynamic (protocol) routes a VRF can have. Syntax maximum dynamic-routes limit {warn-threshold threshold-value | warning-only} To remove the limit on the maximum number of routes used, use the no maximum dynamic-routes command. Parameters limit warningthreshold Maximum number of routes allowed in a VRF. The valid range is from 1 to 16,000 (or maximum allowable for that platform if a smaller value). The warning threshold value is a percentage of the limit value. When the number of routes reaches the specified percentage of the limit, a warning message appears. The valid range is from 1 to 100. After the limit is reached, additional dynamic routes are not allowed. warning-only When you use the warning-only option, when the maximum number of dynamic routes reaches the limit, a warning message appears. After the limit is reached, additional dynamic routes are still allowed. Defaults No limit is set on the maximum number of dynamic routes for a VRF. Command Modes CONFIGURATION-VRF Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) Description Introduced on the S3100 series. Introduced on the S4048-ON. 1816 Virtual Routing and Forwarding (VRF)