Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1280

Related Commands An SPI value must be unique to one IPsec security policy (authentication or encryption) on the router. When you configure encryption for an OSPFv3 area with the area encryption command, you enable both IPsec encryption and authentication. However, when you enable authentication on an area with the area authentication command, you do not enable encryption at the same time. If you have enabled IPsec authentication in an OSPFv3 area with the area authentication command, you cannot use the area encryption command in the area at the same time. The configuration of IPsec encryption on an interface-level takes precedence over an area-level configuration. If you remove an interface configuration, an area encryption policy that has been configured is applied to the interface. To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi number command. • ipv6 ospf encryption - configure an IPsec encryption policy on an OSPFv3 interface. • show crypto ipsec policy - display the configuration of IPsec encryption policies. clear ipv6 ospf process Reset an OSPFv3 router process without removing or re-configuring the process. Syntax Parameters clear ipv6 ospf [vrf vrf-name] process vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to clear IPv6 routes corresponding to that VRF. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) Description Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. 1280 Open Shortest Path First (OSPFv2 and OSPFv3)