Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 535

Version 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 8.3.19.0 8.3.7.0 7.8.1.0 7.7.1.0 Description Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information CAUTION: Dell Networking recommends not changing the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. Related Commands • router bgp - enter ROUTER mode on the switch. show ip bgp dampened-paths View BGP routes that are dampened (non-active). Syntax Parameters show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6 unicast] dampened-paths vrf vrf-name ipv4 unicast ipv6 unicast (OPTIONAL) Enter the keywords vrf and then the name of the VRF to view routes that are affected by a specific community list corresponding to that VRF. (OPTIONAL) Enter the keywords ipv4 followed by the keyword unicast to view information related only to ipv4 unicast routes. (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view information related only to ipv6 unicast routes. Command Modes • EXEC • EXEC Privilege Border Gateway Protocol 535