Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 790

Version pre-Version 6.2.1.0 Description Introduced on the E-Series. Usage Information If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command on the interface. To use the switchport command on an interface, only the no ip address and no shutdown statements must be listed in the show config output. When you enter the switchport command, the interface is automatically added to the default VLAN. To use the switchport backup interface command on a port, first enter the switchport command. For more information, see "Configuring Redundant Links" in the Layer 2 section in the Dell Networking OS Configuration Guide. Egress Interface Selection (EIS) Commands The following commands are Egress Interface Selection (EIS) commands. application Configure the management egress interface selection. Syntax application {all | application-type} To remove a management application configuration, use the no application {all | application-type} command. Parameters application-type Enter any of the following keywords: • For DNS, enter the keyword dns. • For FTP, enter the keyword ftp. • For NTP, enter the keyword ntp. • For Radius, enter the keyword radius. • For sFlow collectors, enter the keyword sflow- collector. • For SNMP (traps and MIB responses), enter the keywords snmp . • For SSH, enter the keyword ssh . • For Syslog, enter the keyword syslog. • For TACACS, enter the keyword tacacs. • For Telnet, enter the keyword telnet. • For TFTP, enter the keyword tftp. 790 Interfaces