Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1734

57 Spanning Tree Protocol (STP) The commands in this section configure and monitor the IEEE 802.1d spanning tree protocol (STP) and are supported on the Dell Networking switch/routing platform. bridge-priority Set the bridge priority of the switch in an IEEE 802.1D spanning tree. Syntax bridge-priority {priority-value | primary | secondary} To return to the default value, use the no bridge-priority command. Parameters priority-value primary secondary Enter a number as the bridge priority value. The range is from 0 to 65535. The default is 32768. Enter the keyword primary to designate the bridge as the root bridge. Enter the keyword secondary to designate the bridge as a secondary root bridge. Defaults priority-value = 32768 Command Modes SPANNING TREE (The prompt is "config-stp".) Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 Description Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. 1734 Spanning Tree Protocol (STP)