Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1183

Related Commands The protocol-specific resolution value calculates the scaled metric by dividing a route's cost by the resolution value set for the route protocol: • For ISIS, you can set the resolution in the range 1 to 1000, where the default is 10. • For OSPF, you can set the resolution in the range 1 to 1592, where the default is 1. • The resolution value used to map static routes is not configurable. By default, Dell Networking OS assigns a metric of 0 to static routes. • The resolution value used to map RIP routes is not configurable. The RIP hopcount is automatically multiplied by 16 to scale it. For example, a RIP metric of 16 (unreachable) scales to 256, which considers the route to be DOWN. • threshold metric - configure the metric threshold used to determine the UP and/or DOWN state of a tracked route. • track ip route metric threshold - configure object tracking on the threshold of an IPv4 route metric. IPv6 Object Tracking Commands The following section describes the IPv6 object tracking commands. The following object tracking commands apply to IPv4 and IPv6: • debug track • delay • description • show running-config track • threshold metric • track interface line-protocol show track ipv6 route Display information about all tracked IPv6 routes, including configuration, current tracked state (UP or DOWN), and the clients which are tracking an object. Syntax show track ipv6 route [brief] Parameters brief (OPTIONAL) Display a single line summary of information for tracked IPv6 routes. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Object Tracking 1183