Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 756

Example (Vlan) Dell(conf-if-vl-20)# interface vlan 10 Dell(conf-if-vl-10)# no untagged gigabitethernet 1/1 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# no tagged gigabitethernet 1/1 Dell(conf-if-vl-20)# interface gigabitethernet 1/1 Dell(conf-if-gi-1/1)# no portmode hybrid Dell(conf-if-vl-20)# rate-interval Configure the traffic sampling interval on the selected interface. Syntax rate-interval seconds Parameters seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299 seconds. NOTE: Because polling occurs every 15 seconds, the number of seconds designated here rounds to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59 seconds rounds to 45. Defaults 299 seconds Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 Description Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the S-Series. Introduced on the C-Series. 756 Interfaces