Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 891

Example Example (Summary) IPv4 Routing Field Description • L1 = IS-IS level-1 • L2 = IS-IS level-2 • IA = IS-IS inter-area • * = candidate default • > = non-active route • + = summary routes The weight for weighted ECMP route calculations is displayed for each path in the route in show ip route command. The ECMP weight is displayed only if weighted ECMP is enabled using the ip ecmp weighted command is enabled. If weighted ECMP is disabled, the show ip route command does not show the weighted ECMP route information. Destination Gateway Dist/Metric Last Change Identifies the route's destination IP address Identifies whether the route is directly connected and on which interface the route is configured. Identifies if the route has a specified distance or metric. Identifies when the route was last changed or configured. Dell# show ip route all Codes:C- connected, S - static, R - RIP B- BGP, IN - internal BGP, EX - external BGP, LO - Locally Originated O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1 N2- OSPF NSSA external type 2, E1 - OSPF external type 1 E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1 L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default >- non-active route + - summary route Gateway of last resort is not set Destination Gateway Dist/Metric Last Change R 3.0.0.0/8 via 100.10.10.10, Gi 2/8 120/1 00:07:12 via 101.10.10.10, Gi 2/9 100.10.10.0/24 Direct, Gi 2/8 0/0 00:08:54 > R 100.10.10.0/24 Direct, Gi 2/8 120/0 00:08:54 C 101.10.10.0/24 Direct, Gi 2/9 0/0 00:09:15 > R 101.10.10.0/24 Direct, Gi 2/9 120/0 00:09:15 Dell# Dell# show ip route summary Route Source Active Routes Non-active Routes connected 2 0 static 1 0 Total 3 0 Total 3 active route(s) using 612 bytes R1_E600i>show ip route static ? | Pipe through a command 891