Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1450

Example 1450 The following describes the test cam-usage service-policy input policy-map stack-unit command shown in the following example. Field Description stack-unit Indicates the stack-unit slot number. Portpipe Indicates the portpipe number. CAM Partition The CAM space where the rules are added. Available CAM Indicates the free CAM space, in the partition, for the classification rules. NOTE: The CAM entries reserved for the default rules are not included in the Available CAM column; free entries, from the default rules space, cannot be used as a policy map for the classification rules. Estimated CAM per Port Indicates the number of free CAM entries required (for the classification rules) to apply the input policy map on a single interface. NOTE: The CAM entries for the default rule are not included in this column; a CAM entry for the default rule is always dedicated to a port and is always available for that interface. Status (Allowed ports) Indicates if the input policy map configuration on an interface belonging to a stack-unit/port-pipe is successful - Allowed (n) - or not successful - Exception. The allowed number (n) indicates the number of ports in that port-pipe on which the Policy Map can be applied successfully. NOTE: In a Layer 2 Policy Map, IPv4/IPv6 rules are not allowed; therefore, the output contains only L2ACL CAM partition entries. Dell# test cam-usage service-policy input pmap_l2 stack-unit all For a L2 Input Policy Map pmap_l2, the output must be as follows, stack-unit|Portpipe|CAM Partition|Available CAM|Estimated CAM per Port |Status | | | |per Port |(Allowed ports) 0 0 L2ACL 500 200 Allowed (2) 0 1 L2ACL 100 200 Exception 1 0 L2ACL 1000 200 Allowed (5) 1 1 L2ACL 0 200 Exception ... ... Quality of Service (QoS)