Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1750

58 System Time and Date The commands in this section configure time values on the system, either using the Dell Networking OS, or the hardware, or using the network time protocol (NTP). With NTP, the switch can act only as a client to an NTP clock host. For more information, see "Network Time Protocol" of the Management section in the Dell Networking OS Configuration Guide. The commands in this chapter are generally supported on Dell Networking OS with some exceptions, as notes in the Command History fields. clock summer-time date Set a date (and time zone) on which to convert the switch to daylight saving time on a one-time basis. Syntax clock summer-time time-zone date start-month start-day startyear start-time end-month end-day end-year end-time [offset] To delete a daylight saving time zone configuration, use the no clock summertime command. Parameters time-zone start-month start-day start-year start-time end-day Enter the three-letter name for the time zone. This name is displayed in the show clock output. Enter the name of one of the 12 months in English. You can enter the name of a day to change the order of the display to time day month year. Enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display to time day month year. Enter a four-digit number as the year. The range is from 1993 to 2035. Enter the time in hours:minutes. For the hour variable, use the 24-hour format; example, 17:15 is 5:15 pm. Enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display to time day month year. 1750 System Time and Date