Dell S3100 Command Line Reference Guide for the Series 9.82.0 - Page 1235

Version 7.8.1.0 7.6.1.0 7.5.1.0 pre- 6.1.1.1 Description Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information You can configure an arbitrary value in the IP address format for each router. However, each router ID must be unique. If you use this command on an OSPF router process, which is already active (that is, has neighbors), a prompt reminding you that changing the router-id brings down the existing OSPF adjacency. The new router ID is effective at the next reload. Example Dell(conf)# router ospf 100 Dell(conf-router_ospf)#router-id 1.1.1.1 Changing router-id will bring down existing OSPF adjacency [y/ n]: Dell(conf-router_ospf)#show config ! router ospf 100 router-id 1.1.1.1 Dell(conf-router_ospf)# no router-id Changing router-id will bring down existing OSPF adjacency [y/ n]: Dell# router ospf To configure an OSPF instance, enter ROUTER OSPF mode. Syntax router ospf process-id To clear an OSPF instance, use the no router ospf process-id command. Parameters process-id Enter a number for the OSPF instance. The range is from 1 to 65535. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.8(2.0) 9.8(0.0P5) Description Introduced on the S3100 series. Introduced on the S4048-ON. Open Shortest Path First (OSPFv2 and OSPFv3) 1235