Epson FX-286 User Manual - Page 177
Running the self test in the IBM Proprinter mode, FX-286
View all Epson FX-286 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
The DIP switch settings for the Standard and Alternate sets are: DIP Switch 1-6 1-7 1-8 Standard ON ON ON Alternate Set any one of these three switches to OFF. Running the self test in the IBM Proprinter mode If you want to run a self test to see what the IBM Proprinter charac- ter sets look like, you only have to reset DIP switch 1-4 from ON to OFF. To run the self test, make sure the power is OFF, then hold down the DRAFT button while turning the power switch ON-the self test takes over and the FX-286 starts printing out the Standard IBM Pro- printer character set, as shown in Figure J-1. Figure J-1. IBM Proprinter mode self test If you want to see the Alternate set, turn the power OFF. Then reset either switch 1-6, 1-7, or 1-8 from ON to OFF, and run the self test again. Remember, you must also reset DIP switches 2-1 and 2-3 as previ- ously mentioned if you want to select the IBM Proprinter mode for uses other than the self test. J-3