Epson FX-286 User Manual - Page 96

Running the program Now run the program. For each of the nine columns, the program asks for the numbers of the rows in which you want dots to appear. Enter the row numbers one at a time, pressing the RETURN key after each one. When you have entered all the numbers for a column or when you want no dots in a column, press RETURN without a num- ber. Remember that the vertical lines in the grid are the evennumbered columns. To see program 1 produce the character in Figure 7-4 run the program and follow these instructions: When the screen message asks what rows have dots in column 1, respond with RETURN to indicate that no dots go in that column. For column 2 (the vertical line), press 7, RETURN, 5, and RETURN again to indicate that you want dots in rows 7 and 5. Then press RETURN alone to indicate that no more dots go in column 2. For column 3 press 8, 6, 4, and 2, with a RETURN after each of them. Then press RETURN to finish with column 3 and go on to column 4. For column 4 press RETURN only. (The rest of the directions assume that you know to press RETURN after each number and one extra time to end the entries for each column.) For column 5, enter 6, 4, 3, 2, and 1. For column 6, press RETURN only; for column 7 enter 8, 6, 4, and 2; for column 8 enter 7 and 5; and for column 9 press RETURN only. Now wait a moment for your computer to calculate the dot patterns and your FX-286 to print the new character in two different typestyles. Your printout also gives you nine numbers, which you will use in the next program. You should get the printout you see below: YOUR CHARACTER IN PICA:: IN EXPANDED EMPHASIZED PICA: YOUR DATA NUMBERS: 0 80 170 0 47 0 170 80 0 When you get to this point with a character of your own, you see how it looks and whether or not you like it. If you want to make any changes, move the dots on the grid as needed and re-run the program. 7-5