Fujitsu 6770 Operator's Guide - Page 128
Attach the Brake Roller to the scanner., Close the ADF., Reset the brake roller counter
UPC - 097564307478
View all Fujitsu 6770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Chapter 7 Consumables 6 Attach the Brake Roller to the scanner. 1 Put the Brake Roller by adjusting the flat section of the rotating shaft to the guide slot of the Brake Roller Holder. 2 Close the Brake Roller Holder. 7 Close the ADF. Press down on the center of the ADF to return it to its original position until the ADF clicks into place. CAUTION Be careful, the ADF may close and pinch your fingers. ʂ • Do not close the ADF while the Brake Roller Cover is kept open. • Confirm that the Brake Roller is attached firmly. If not, paper feed errors such as multifieeds will occur. 8 Reset the brake roller counter. Start up the Software Operation Panel, and then reset the counter. For details, refer to "Resetting the counters" (on page 166). TOP Contents Index Introduction Scanner Overview Loading Documents How to Use ScandAll PRO Scan Parameters Various Documents Daily Care Consumables Troubleshooting Operational Settings Appendix Glossary 128