Fujitsu 6770 Operator's Guide - Page 76
Scanning Documents of Different Widths
UPC - 097564307478
View all Fujitsu 6770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Chapter 5 Various Documents 4 Select [Flat Bed] under [Scan Type]. 5 Specify a desired paper size from [Paper Size], etc. 6 Click the [OK] button. ⇒ The changes made are applied. 7 From ScandAll PRO, perform a scan. For how to perform a scan, refer to "Chapter 3 How to Use ScandAll PRO" (on page 51). CAUTION Never look into the light source directly during scanning. ʂ • Do not move the document during scanning. • For a document of up to A3 or Double Letter size, be sure to close the Document Cover before scanning. Scanning Documents of Different Widths When you scan documents of different widths, scan them, following the procedure below. ʂ When you scan documents of different widths at one time from the ADF, some documents that are small in paper size may be skewed or may not be fed into the scanner. It is recommended that only documents of the same width be scanned at one time. 1 To prevent images from being skewed, select [Automatic Page Size Detection] from the [Automatic Size and Skew Detection] drop-down list. For how to configure the settings, refer to "Automatically Correcting Skewed Document Images" (on page 87). 2 Center all the document sheets as shown in the figure below. TOP Contents Index Introduction Scanner Overview Loading Documents How to Use ScandAll PRO Scan Parameters Various Documents Daily Care ʂ Inside the opening of the ADF is a Pick Roller, which picks and feeds documents into the ADF. Therefore, off-center documents, if out of contact with the Pick Roller, cannot be fed into the scanner. Consumables Troubleshooting Operational Settings Appendix Glossary 76