Garmin GTN 750 Pilot's Guide - Page 319

In Point-To-Point mode these are manually selected waypoints (if there is an active flight plan, these default to the endpoints of the active leg). Foreword Some of the calculated trip statistics are dashed when the selected leg of the active flight plan has already been flown. • Desired Track (DTK) - DTK is shown as nnn° and is the desired track between the selected waypoints. It is dashed unless only a single leg is selected. Getting Started Audio & Xpdr Ctrl Com/Nav • Distance (DIS) - The distance is shown in tenths of units up to 99.9, and FPL in whole units up to 9999. • Estimated time en route (ETE) - ETE is shown as hours:minutes until less Direct-To than an hour, then it is shown as minutes:seconds. Proc • Estimated time of arrival (ETA) - ETA is shown as hours:minutes and is the local time at the destination. Charts - If in Point-To-Point mode then the ETA is the ETE added to the departure time. Wpt Info - If a flight plan other than the active flight plan is selected it shows the Map ETA by adding to the departure time all of the ETEs of the legs up to and including the selected leg. If the entire flight plan is selected, Traffic then the ETA is calculated as if the last leg of the flight plan was selected. Terrain - If the active flight plan is selected the ETA reflects the current position of the aircraft and the current leg being flown. The ETA is calculated Weather by adding to the current time the ETEs of the current leg up to and including the selected leg. If the entire flight plan is selected, then the Nearest ETA is calculated as if the last leg of the flight plan was selected. Music • En Route safe altitude (ESA) - The ESA is shown as nnnnnFT • Destination sunrise and sunset times - These times are shown as Utilities hours:minutes and are the local time at the destination. System Messages Symbols Appendix 190-01007-03 Rev. B Garmin GTN 725/750 Pilot's Guide 15-13 Index