HP ET115AV HP xw4400 Workstation - Service and Technical Reference Guide - Page 68
System board architecture, Steps for removal and replacement of components
View all HP ET115AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Table 4-3 System board components (continued) No. Component No. Component No. Component 7 Memory module sockets 18 Front USB 29 Network/USB 8 Main power 19 Hard disk activity LED 30 Audio 9 Diskette drive 20 Internal USB 31 USB 10 Primary IDE 21 Speaker 32 Parallel 11 Chassis intrusion switch 22 Front audio 33 Serial * Electrically x4 bandwidth 34 Keyboard/Mouse System board architecture The following image shows the HP xw4400 Workstation block diagram. Figure 4-3 System board block diagram Steps for removal and replacement of components This section discusses the procedures necessary to remove and install various hardware components on your workstation. Review the safety and precautions and the Service considerations on page 52, as well as the Safety and Regulatory Information, before servicing or upgrading your system. 1. Read all safety information and precautions. 2. Locate and clear a suitable work area. 3. Shut down the system and remove power from the unit. 58 Chapter 4 Removal and replacement procedures ENWW