HP ET115AV HP xw4400 Workstation - Service and Technical Reference Guide - Page 88
IEEE-1394 (optional
View all HP ET115AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
To install a PCI card: 1. Disconnect power from the system (Predisassembly procedures on page 57), remove the side access panel (Side access panel on page 62), and remove the PCI retainer (PCI retainer on page 74), if installed. 2. Lift the PCI levers (1) by first pressing down and then up. 3. Remove the PCI slot cover (2). 4. Lower the PCI (3) card into the chassis. Verify that the keyed components of the card align with the socket. 5. Close the PCI retention clamp (4) by rotating the clamp downward and pushing on the two green snaps down from the rear panel of the chassis. Figure 4-26 Installing the PCI card IEEE-1394 (optional) To remove an IEEE-1394 card: 1. Disconnect power from the system (Predisassembly procedures on page 57), remove the side access panel (Side access panel on page 62), and remove the front bezel (Front Bezel on page 63). 2. Lift the PCI levers (1) by first pressing down and then up. 3. Disconnect the front I/O cable and power cable (2) from the card. 4. Lift the IEEE card (3) out of the chassis. Store the card in an anti-static bag. 78 Chapter 4 Removal and replacement procedures ENWW