HP ET115AV HP xw4400 Workstation - Service and Technical Reference Guide - Page 95
Optical drive (Desktop position),
View all HP ET115AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
4. Connect the power, drive, and audio (if required) cables to the drive and system board. On Linux systems, connect the audio cable to the AUX-IN connector. NOTE: The audio cable is only required for Linux-based systems. Figure 4-35 Installing the optical drive Optical drive (Desktop position) To remove an optical drive: 1. Disconnect power from the system (Predisassembly procedures on page 57), remove the side access panel (Side access panel on page 62) and remove the front bezel (Front Bezel on page 63). 2. Disconnect the data (1), power (2), and audio (3) cables from the drive. The connector colors might be different than illustrated. NOTE: The audio cable is only required for Linux-based systems. Figure 4-36 Disconnecting the cables from the optical drive ENWW Steps for removal and replacement of components 85