HP Workstation i2000 hp workstation i2000 owner's guide (a6037-90003) - Page 89
Removal of the Baseboard
View all HP Workstation i2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
hp workstation i2000 owner's guide 7.6 Removal of the Baseboard 1. Prior to removing the system baseboard, all board and cards described previously must be removed. 2. Remove all fan power connectors from the baseboard. 3. Locate and remove the four- (4) screws (two- [2] each) from the memory card retention posts. Refer to Figures 47 and 48. 4. Locate the fan card guide, refer to Figure 48 and remove the one- (1) screw securing the module to the chassis. Apply pressure along the top of the card guide (from the rear) pushing it inward (toward the baseboard) to disengage the mounting clips located at the bottom. /NOTE The forward memory, card retention post has a cooling fan mounted to it. Do not remove the fan from the retention post. Refer to Figure 47 and Figure 49. Cooling Fan for AGP I/O Cooling Fan Figure 46. Fan Card Guide 89