HP Workstation i2000 hp workstation i2000 owner's guide (a6037-90003) - Page 99
I/O Board Installation
View all HP Workstation i2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
hp workstation i2000 owner's guide 8.3 I/O Board Installation 8.3.1 Preparing the I/O Board To replace or upgrade the I/O board, the mounting bracket must be removed from the original I/O board and reinstalled on the upgrade I/O board. 1. To remove the I/O mounting bracket from the I/O board, remove the two- (2) Phillips-head screws securing the board to the bracket. 2. Remove (unsnap) the plastic retaining foot from the I/O PCB. 3. Reverse the procedure by placing the bracket on the upgrade I/O board. 4. Install (snap) on the new PCB. 5. Replace and tighten the two- (2) screws securing the bracket to the board. 8.3.2 Installing the I/O Board 1. Align the I/O bracket to the chassis and the card edge connector into the system baseboard, ensuring that the I/O card is completely seated into the I/O slot. 2. Reinstall the I/O bracket retaining screw that holds the I/O bracket to the rear of the system. Refer to Figure 45. 3. Reinstall the two- (2) screws at the top of the I/O bracket, mounting it to the inside of the system. 4. Reconnect all the connectors and cables. Refer to Figure 54 for connection locations on the I/O board. CAUTION When you install the I/O Board, avoid damaging the EMI gaskets mounted on the rear. Replace any damaged strips, or your system may not meet EMI requirements. 99