IBM 86624RY Maintenance Manual - Page 124

indicates that it is not responding.) If there is more than one ServeRAID adapter or controller in the system, selectce on the appropriate adapter or controller to make it active. You can then monitor the status by clicking on the active adapter button on the Main screen of the Administration and Monitoring Program. Note You might need to use the scroll bar and scroll down to see all of the items that appear on this screen. Descriptions of the information that appears on the screen are as follows: Adapter Number The active adapter or controller (1 to 8). Number of Logical Drives The number of defined logical drives (0 to 8). Unattended Mode Off - The user chooses the recovery method when there is a ServeRAID startup error. On - The adapter or controller chooses the recovery method when there is a ServeRAID startup error. Code Block Version The current version number of the firmware loaded on the adapter or controller. Boot Block Version The current version number of the bootable microcode loaded on the adapter or controller. Concurrent Commands The maximum number of concurrent commands supported. Maximum Devices Supported The maximum number of devices supported. Flash Program Count The current number of times the flash EEPROM has been written. Defunct Disk Count The current number of defunct hard disk drives. Rebuild Rate The current setting (Low, Medium, or High) of the rebuild rate. Hot-Swap Rebuild The current state (Enabled or Disabled) of the hot-swap rebuild feature. Offline Logical Drive Count The current number of offline logical drives. Configuration Update Count The number of times that the ServeRAID configuration has been updated. NVRAM Battery Backup Device The current state of the battery-backup cache (installed, not installed, or defective). 116 Netfinity Server HMM