IBM 86624RY Maintenance Manual - Page 135

Supported operating systems: DOS Command: IPSSEND STARTDELY Controller Options Replace: Controller with the ServeRAID controller number (1 to 8) Options with a question mark (?) to display concurrent drive startup count: Drive Count (1 to 16) and Delay Time (3 to 15 seconds). RAID configuration commands: The IPSSEND RAID configuration commands include the following: DRIVEVER Use the DRIVEVER command to display the vendor ID, microcode version, and serial number of a SCSI device. The IPSSEND program retrieves this information directly from the device. Supported operating systems: Windows NT, OS/2, NetWare, OpenServer, UnixWare, and DOS Command: IPSSEND DRIVEVER Controller Channel SID Replace: Controller with the ServeRAID controller number (1 to 8) Channel with the channel number for the device (1, 2, or 3) SID with the SCSI ID for the device (0 to 15) GETCONFIG Use the GETCONFIG command to display the ServeRAID adapter or controller configuration information. This includes information about the firmware version; initiator ID and rebuild rate; logical drive status, RAID level, and size; and physical device type, SCSI ID, and PFA error. Supported operating systems: Windows NT, OS/2, NetWare, OpenServer, UnixWare, and DOS Command: IPSSEND GETCONFIG Controller Options Replace: Controller with the ServeRAID controller number (1 to 8) Options with one of the following: AD for adapter or controller information, LD for logical drive information, PD for physical device information, AL (default) for all information. Netfinity 5500 M20 - Type 8662 127