IBM 86624RY Maintenance Manual - Page 182

"Preparing to install options" on page 246); then remove the top cover (see "Top cover removal" on page 284). 2. Locate the battery on the system board (see "System board component locations" on page 279). 3. Remove any adapters that are installed in PCI slots 1 and 2, so you can access the battery. (See "Hot-plug PCI adapter installation" on page 165 for information about installing and removing adapters from the hot-plug PCI slots.) 4. Lift and remove the plastic dividers between PCI slot 1 and the ISA slot and between PCI slot 1 and PCI slot 2 by pressing the latches on the top ends of the dividers toward the dividers and lifting the dividers from the server. 5. Remove the battery: a. Use one finger to lift the battery clip over the battery. b. Use one finger to slightly slide the battery toward the rear of the server. The spring mechanism behind the battery will push it out toward you as you slide it forward. c. Use your thumb and index finger to pull the battery from under the battery clip. d. Ensure that the battery clip is touching the base of the battery socket by pressing gently on the clip. 6. Insert the new battery: a. Tilt the battery so that you can insert it into the front of the socket, under the battery clip. b. As you slide it under the battery clip, press the battery down into the socket. 7. Reinstall any adapters you removed. (See "Hot-plug PCI adapter installation" on page 165 for information about installing and removing adapters from the hot-plug PCI slots.) 8. Insert the plastic dividers into the divider guides beside PCI slots 1 and 2. 9. Reinstall the top cover and complete the installation (see "Completing the installation" on page 178). 174 Netfinity Server HMM