IBM 86624RY Maintenance Manual - Page 279

Note If you are in the United Kingdom, you must perform this step before disconnecting the power cords. 2. Disconnect all cables and power cords from the rear of the server. 3. Disconnect all power cords from the rack. 4. Remove the screws from the bezel brackets on each side of the front bezel. Set them aside for later use. 5. Slide the server about halfway out of the rack. 6. Loosen the captive screws that secure the cable-management arm. 7. Fully extend the slide-bracket assemblies until they lock. 8. Remove the screws that attach the server to each slide-bracket assembly. 18 kg (37 lbs) 32 kg (70.5 lbs) Caution Use safe practices when lifting. 55 kg (121.2 lbs) 9. Install the four lift handles on the sides of the server: a. Press in on the sides of the lift handle near the tabs and insert the handle tabs into the slots on the side of the server. b. Move the handle up in the slots so that the hooked part of each tab is inside the server. Release the pressure on the sides of the handle. c. Install the remaining three lift handles. Netfinity 5500 M20 - Type 8662 271